What are the correct selection methods for the pneumatic motor? Below is the company's technical staff to give you a brief introduction, I hope that our introduction can help you better.

1. At the same power, the vane motor is smaller, lighter and cheaper than the piston type motor. Because of the simple design and manufacture, it can be applied in almost all areas. The vane motor can work in a wide range of speed and torque, and it is the most widely used type of gas motor.

2, radial (radial) piston type pneumatic motor: its speed is lower than that of vane motor, but it has excellent performance of starting and speed control, especially for radial heavy duty and low speed. The piston type pneumatic motor can be operated horizontally.

3, reversible / irreversible motor: in the same type, the rotational speed, torque and power of the irreversible pneumatic motor are higher than that of the reversible pneumatic motor.

4, working air pressure: when selecting the gas motor, the performance table shows a set of performance parameters for the gas to reach the specific working air pressure at 90psig (620Kpa), and the motor is in the best design state when working air pressure. By adjusting the inlet and outlet pressure, speed, torque and power can be infinite gas motor section adjustment; when the air motor in the working pressure is lower than 40psig, its performance may not very stable pneumatic motor can work under pressure higher than 100psig, but the roller wear in the pneumatic motor model can be determined follow a principle: to provide the minimum pressure of 70% as the base to choose which allows the selected pneumatic motor will have sufficient power to cope with the overload starting impact and possible.

5, the maximum power of the pneumatic motor is: the maximum power of the non speed limiting pneumatic motor reaches the speed limit when the 50% speed of the free speed (no load speed) is reached, and the maximum power of the pneumatic motor is achieved at the 80% speed of the free speed (no load speed).

6, working speed: the speed limit pneumatic motor will not run empty.

Pneumatic motor speed can be found in the performance curve, the nominal speed on the nameplate is only for individual.

7, working torque; in determining the model of the gas motor, the same important thing as the speed is the working torque, and the two parameters determine the power of the gas motor. The difference between the static (maximum) torque and the working torque should be paid attention to in the selection.

8, pneumatic motor speed and torque: starting torque is about 75% of the maximum torque torque (at different speeds), can be found on the pneumatic motor performance curve or the following formula to calculate torque (pound, English) = horse power. 5250/ speed (r/min torque (N). M) =KW.9550/ speed (r/min)

Do you know the correct choice of the pneumatic motor through the technical staff of the company? If you want to know more about it, please continue to pay attention to us.