What are the methods and techniques for the use and maintenance of pneumatic products? Next, there are pneumatic motor manufacturers to introduce to you, I hope that our introduction can help you better.

1, ensure the right generation of gas supply system: the inlet pressure at the tool inlet (the outlet pressure of the non air compressor) is generally 90PSIG (6.2Kg/cm^2), too high or too low, which will damage the performance and life of the tool. The intake must contain enough lubricating oil to fully lubricate the pneumatic motor in the tool. It can set up a white paper to check whether there is oil stain at the tool exhaust and normal oil stain. The intake must be not water - free, if the air without air dryer is not appropriate.

2. The operation of the tool can not be dismantled without any dismantling of the tool, except that it will affect the safety of the operator and cause the tool to be damaged.

3, if the tool has a slight failure or can not be used to achieve the original function, it should not be used again and should be checked immediately.

4. Use all kinds of tools, be sure to comply with all kinds of safety regulations and instructions.

5, to choose the appropriate tool work, tools too easy to cause work harm, tools too small easy to cause damage to the tool.

6, regular (about once a week) inspection, maintenance tools, add butter to the bearing and other rotating parts, add oil to the pneumatic motor parts.

Do you know the methods and techniques of using and maintaining the pneumatic products through the pneumatic motor manufacturers? If you want to learn more knowledge, please continue to pay attention to us.